syoung_2000
08-23-2007, 03:12 PM
I ordered this link from bikebandit for my 400ex. They said it was a master link. I was expecting there to be that long c shaped clip.
It just had a solid end to slide on with no place to slide that clip onto and one was not including.
How does this type install? All I could think to do was use vise grips and clamp the side piece over those two little rods?
It's # 14 on this webpage. It's referred to as a joint set (daido)
http://houseofmotorcycles.bikebandit.com/parts/Honda/TRX400EX+FOURTRAX+EX/2001/386590
Did I install it right or is there another way? It's on there tight, but I'd hate it to pop off while I'm riding up a steep hill if I didn't do it right
Thanks in advance everyone!
It just had a solid end to slide on with no place to slide that clip onto and one was not including.
How does this type install? All I could think to do was use vise grips and clamp the side piece over those two little rods?
It's # 14 on this webpage. It's referred to as a joint set (daido)
http://houseofmotorcycles.bikebandit.com/parts/Honda/TRX400EX+FOURTRAX+EX/2001/386590
Did I install it right or is there another way? It's on there tight, but I'd hate it to pop off while I'm riding up a steep hill if I didn't do it right
Thanks in advance everyone!