beerock
12-11-2002, 02:55 PM
This is tants frame (nasty250r)
two of my friends and I are jealous of this frame because of the gusseted plates under the motor mounts.(ours dont have them YET)- the pic is in the bottom right corner
the revisions are :
NEW two 1/8" thick plates underneath the bottom motor mounts.
(I saw this done to a 400ex and adapted it to the R)- if anyone can find that pic please post it!
I lengthened the tubes by the shock towers by 2-3cm
I shortened the height of the frame gussets where the frame and subframe meet. The gussets on my frame are a little to close for comfort to the master cylinder mount, but i havent had a problem.
Everything else is fairly close to my first design which was on my frame(and 2 others).
The only thing needed to be done now is drill the holes for the skids and grind some of the welds to clean them up. :D :cool:
two of my friends and I are jealous of this frame because of the gusseted plates under the motor mounts.(ours dont have them YET)- the pic is in the bottom right corner
the revisions are :
NEW two 1/8" thick plates underneath the bottom motor mounts.
(I saw this done to a 400ex and adapted it to the R)- if anyone can find that pic please post it!
I lengthened the tubes by the shock towers by 2-3cm
I shortened the height of the frame gussets where the frame and subframe meet. The gussets on my frame are a little to close for comfort to the master cylinder mount, but i havent had a problem.
Everything else is fairly close to my first design which was on my frame(and 2 others).
The only thing needed to be done now is drill the holes for the skids and grind some of the welds to clean them up. :D :cool: