doublejz
07-29-2014, 07:49 AM
So I finally got working on my rebuild, details below.
Kibblewhite Black Diamond Intake and Exhaust Valves 1mm Over
Hot Cams Stage 2
Wiseco 11:1 416 piston (87mm)
Install GT Thunder 400EX Heavy Duty Head studs
Port and Polish
3 or 5 Angle Valve Job - not sure yet
Full White Brothers exhaust
I'm thinking that when I get everything back together I should start around the following but then again, I have no idea...
170 Keihin jet
3rd clip down on the needle
2 3/4 turn out on the a/f screw mixture.
Any suggestions? I'm roughly at 1,100 ft elevation. Also, if it matters I plan on running one step colder plug (dpr9z) and straight race gas (108).
Kibblewhite Black Diamond Intake and Exhaust Valves 1mm Over
Hot Cams Stage 2
Wiseco 11:1 416 piston (87mm)
Install GT Thunder 400EX Heavy Duty Head studs
Port and Polish
3 or 5 Angle Valve Job - not sure yet
Full White Brothers exhaust
I'm thinking that when I get everything back together I should start around the following but then again, I have no idea...
170 Keihin jet
3rd clip down on the needle
2 3/4 turn out on the a/f screw mixture.
Any suggestions? I'm roughly at 1,100 ft elevation. Also, if it matters I plan on running one step colder plug (dpr9z) and straight race gas (108).